Axia Analog Node Manual do Utilizador descarregar pdf (Página 2)

IMPORTANT NOTE:

Axia nodes are intended for use with an Ethernet

Switch that supports multicast and QOS (Quality

of Service). On a non-switched Ethernet hub, or a

switch that is not enabled for multicast, this will re-

sult in network congestion that could disrupt other

network activity. Should you wish to connect a node

to a non-Livewire network for access to the web con-

ﬁguration interface, etc, you must ﬁrst conﬁrm that

streaming is disabled as described in Section 2 page

6 “Programming the Node’s Streaming Mode”.

USA Class A Computing Device

Information To User. Warning:

This equipment generates, uses, and can radiate ra-

dio-frequency energy. If it is not installed and used

as directed by this manual, it may cause interference

to radio communication. This equipment complies

with the limits for a Class A computing device, as

speciﬁed by FCC Rules, Part 15, Subpart J, which

are designed to provide reasonable protection against

such interference when this type of equipment is op

erated in a commercial environment. Operation of

this equipment in a residential area is likely to cause

interference. If it does, the user will be required to

eliminate the interference at the user’s expense.

NOTE: Objectionable interference to TV or radio

reception can occur if other devices are connected to

this device without the use of shielded interconnect

cables. FCC rules require the use of only shielded

cables.

Canada Warning:

“This digital apparatus does not exceed the Class A

limits for radio noise emissions set out in the Radio

Interference Regulations of the Canadian Depart-

ment of Communications.” “Le present appareil nu

merique n’emet pas de bruits radioelectriques depas

sant les limites applicables aux appareils numeriques

(de les Class A) prescrites dans le Reglement sur le

brouillage radioelectrique edicte par le ministere des

Communications du Canada.”

Important Safety Information

To reduce the risk of electrical shock, do not expose

this product to rain or moisture. Keep liquids away

from the ventilation openings in the top and rear of

the unit. Do not shower or bathe with the unit.

Caution

The installation and servicing instructions in the

manual are for use by qualiﬁed personnel only. To

avoid Electric Shock, do not perform any servicing

other than that contained in the operating instructions

unless you are qualiﬁed to do so. Refer all servicing

to qualiﬁed personnel.

Electrical Warning

To prevent risk of electric shock: Disconnect power

cord before servicing.

This equipment is designed to be operated from a

power source that includes a third “grounding” con

nection in addition to the power leads. Do not defeat

this safety feature. In addition to creating a potential-

ly hazardous situation, defeating this safety ground

will prevent the internal line noise ﬁlter from func-

tioning.

Ventilation Warning

The Axia 8x8 node uses convection cooling. Do not

block the ventilation openings in the side of the unit.

Failure to allow proper ventilation could damage the

unit or create a ﬁre hazard. Do not place the unit on

a carpet, bedding, or other materials that could inter

fere with the rear and top panel ventilation openings.

1 2 3 4 5 6 7 ... 34 35

Comentários a estes Manuais

Sem comentários

Axia Analog Node Manual do Utilizador Página 2

Comentários a estes Manuais