Axia Analog Node Manual do Utilizador descarregar pdf (Página 15)

2: Operation Via the 8x8's Front Panel • 7

Version 2.0, February, 2007

If you have read the Introduction to Livewire; Sys-

tem Design Reference & Primer manual, you will know

that no each stream must have a unique channel number,

so don’t forget that now.

To program the node’s Transmit Base Channel fol-

low these steps:

Starting from the metering screen, press the <SE

LECT> button 5 times. The default TxBCH is

“00001”, so unless the unit has previously been pro

grammed, the display will show that entry.

Press and hold the <ID> button for 4 seconds. A

blinking cursor will appear below the ﬁrst digit. Use

<SELECT> to change the digit indicated by the cur

sor (each press of this number will increment the dis

played digit by one).

Press the <ID> button to jump to the next digit. Use

<SELECT> to change the digit indicated by the cur-

sor. Continue until all digits of the TxBCH have been

entered.

Once the changes are complete, press the <ID> but-

ton repeatedly until no cursor is shown then press

<SELECT> to exit.

If you do not wish to save your changes do not press

<SELECT> after reaching the last digit. After ap

proximately 10 seconds the display will return to the

meter screen and the old settings will be restored.

Programming the unit’s Receive Base Channel

(RxBCH)

The Receive Base Channel is the number assigned to

the ﬁrst of the eight streams to be received by this node

and output from its audio connectors. If the Receive Base

Channel is set to 00201 then the system will search the

Livewire network for eight streams on channel numbers

00201 through 00208. If a designated stream(s) is(are)

present the node will indicate this by illuminating the

lowest LED segment on the corresponding output meter.

Of course in many scenarios you will want to use non-

contiguous numbering for receive channels; these must

be assigned using the node’s web interface, see section 3

Advanced Programming.

To program the node’s Receive Base Channel follow

these steps:

Starting from the metering screen, press the <SE

LECT> button 6 times. The default RxBCH is

“00001”, so unless the unit has previously been pro

grammed, the screen will show that entry.

Press and hold the <ID> button for 8 seconds. A

blinking cursor will appear below the ﬁrst digit. Use

<SELECT> to change the digit indicated by the cur

sor (each press of this number will increment the dis

played digit by one).

Press the <ID> button to jump to the next digit. Use

<SELECT> to change the digit indicated by the cur

sor. Continue until all digits of the TxBCH have been

entered.

Once the changes are complete, press the <ID> but

ton repeatedly until no cursor is shown then press

<SELECT> to exit.

If you do not wish to save your changes do not press

<SELECT> after reaching the last digit. After ap

proximately 10 seconds the display will return to the

meter screen and the old settings will be restored.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 34 35

Comentários a estes Manuais

Sem comentários

Axia Analog Node Manual do Utilizador Página 15

Comentários a estes Manuais