Axia Analog Node Manual do Utilizador descarregar pdf (Página 17)

3: Advanced Programming • 9

Version 2.0, February, 2007

Chapter Three:

Advanced Programming

Using the node’s built in web pages to conﬁgure

advanced features is fast and easy.

Assigning an IP Address Remotely

If you have not assigned an IP address you must do

so. You can do this from the front panel as described in

section 2, or the node’s IP address can be remotely as-

signed over the network using a program included with

the your node called BootP. To do so follow these steps:

Start bootps.exe program on any Windows 2000/XP

Hit ID button on GPIO front panel.You will be

prompted for new IP address entry:

Enter new IP address and press ENTER:

IMPORTANT NOTE: Axia nodes are intended for

use with an Ethernet Switch that supports mul

ticast and QOS (Quality of Service). On a non-

switched Ethernet hub, or a switch that is not

enabled for multicast, this will result in network

congestion that could disrupt other network

activity. Should you wish to connect a node to

a non-Livewire network for access to the web

conﬁguration interface, etc, you must ﬁrst con

ﬁrm that streaming is disabled as described

in Section 2 page 6 “Programming the Node’s

Streaming Mode”.

Make note of the IP address you have entered, so that

you can access the Node using a Web browser, see sec-

tion 3. You can now continue to assign additional Node

IP addresses, or shut down the Bootp program.

Accessing the Node’s Web Pages

IMPORTANT NOTE: Axia nodes are intended for

use with an Ethernet Switch that supports mul

ticast and QOS (Quality of Service). On a non-

switched Ethernet hub, or a switch that is not

enabled for multicast, this will result in network

congestion that could disrupt other network

activity. Should you wish to connect a node to

a non-Livewire network for access to the web

conﬁguration interface, etc, you must ﬁrst con

ﬁrm that streaming is disabled as described

in Section 2 page 6 “Programming the Node’s

Streaming Mode”.

A number of parameters may be conﬁgured using the

Livewire nodes built in web pages. To access the built

in web server from a computer, the computer and node

must be connected to the same LAN (or the computer

and node can be connected using a “crossover 10/100

Base-T” Ethernet cable). To connect enter the following

in your browser:

http://123.456.789.101

where “123.456.789.101 is the IP address if the node

to be conﬁgured.

Your browser should now display the login window

to allow you to access the node:

Enter a valid user name and password and click on

“OK” to log in.

The default user name for all Axia nodes is: “user”

The default password for all Axia nodes is: <enter>

NOTES:

The IP range (e.g. the ﬁrst three numbers of the four

numbers of the IP address of the computer and the

node must match, or additional conﬁguration and

router will be required.

Microsoft Internet Explorer version 5 and later have

been tested with the Livewire 8x8 Nodes. Other

browsers may work, however they have not been

tested.

Your browser must have Java enabled and must allow

“pop up” windows.

Once you have logged in you will see the Axia 8x8

node home page as shown here:

•

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 34 35

Comentários a estes Manuais

Sem comentários

Axia Analog Node Manual do Utilizador Página 17

Comentários a estes Manuais